Whether you’re a seasoned stoner or new to the cannabis game, it’s important to learn how to pack a blunt. It consists of a loose tobacco leaf or flavored blunt wrap filled with cannabis. However, unless you’re a pro, learning how to pack a blunt perfectly is a whole different story. If you aren’t sure about what you’re doing, it can ruin the entire experience.
An unskilled toker might fumble around with the blunt wrap, cut themselves trying to prep the leaf, lose a bunch of herb because it fell out while they were rolling it, or finally get it rolled up just to end up with a soft, flabby blunt. Yikes.
Learning how to pack blunt cones takes most of the mastery out of the equation. Instead of rolling up a blunt from scratch, they make it quick and easy. You just prep your herb, drop it into the blunt cone, seal it, and enjoy.
While it’s much easier than rolling up a blunt the old-fashioned way, learning how to pack a cone might take a little trial and error at first — especially if you’re a beginner. Don’t worry though — we got you.
Here are some pointers for how to pack a cone:
1. Prep Your Herb
The first step in how to pack cones, you have to grind your cannabis. You can do this by breaking it up by hand, but a grinder breaks down your herb as finely as possible (much better than our fingers can). The smaller the pieces, the easier it will be to pack your blunt cone. Make sure you use a sufficient amount of bud to pack the blunt cone tightly.
Otherwise, you’ll have a hard time figuring out how to pack a cone tightly, which will make for a very unpleasant toke sesh. When you’re done grinding it all up, set it aside and pick out any stems to make for the perfect blunt-smoking experience.
2. Fill Up Your Blunt Cone
Once you’ve prepped your bud, it’s time to figure out how to pack the cone. It is as easy as picking up the pieces of marijuana and dropping it into your cone. You can use your finger or tweezers — whatever is more comfortable for you.
A pro-tip for how to pack cones with no fall-out: lay your ground-up bud on the center of a piece of paper, fold it in half, and hold the fold over the top of the blunt cone — the herb will fall perfectly into the opening. Be sure not to grip the filter too hard while you’re holding the blunt cone or you might ruin it.
3. Pack Your Blunt Cone
When you’ve filled up your blunt cone with all the herb you can, it’s time to pack it. You can do this with any long, slender item — a chopstick, the back of a pen or pencil, or a cone stuffer.
When it comes to how to pack a blunt, there are 2 ways you can go about it: you can either fill up the cone first (like we did here) and pack it up at the end, or fill and pack as you go. With time, you’ll find your sweet spot and figure out how to pack a cone your own way.
As you pack the cone, the herb will become more compact, so be sure to add a little more as needed to prevent a flabby cone.
4. Seal Your Blunt Cone
Now that you’ve learned how to pack a cone, you need to seal it properly so you can enjoy it. First, make sure the top of the cone has a little room for you to twist it closed. If not, you may have overfilled your cone.
If you find you have too much room at the top but don’t have any more herb, you can sprinkle in a pinch of kief (from your grinder chamber) to the top for some extra flavor and added psychedelic effect.
Otherwise, trim it down to size. Once you’ve got that part sorted, twist the top of the cone as tightly as you can. After that, you’re all set.
5. Spark Up & Enjoy
Voila! You’ve now learned how to successfully pack a cone. Admire the beauty of your quintessential bluntski, find a relaxing spot, and light it up. Enjoy it solo or puff, puff, pass with some friends.
We promise that once you start learning how to pack blunt cones, your blunts will never be the same. Your days of cracking your tobacco leaf the wrong way, losing bud in the crevices of your workspace, and loose, saggy spliffys are but a distant memory.
Using Rolling Papers vs Pre Rolls
But what are the benefits of learning how to pack a cone vs. using rolling papers? Both will get you the same results, however one is more difficult than the other. Learning how to roll a joint with rolling papers from scratch is an art that takes time to learn. While learning how to pack a cone also requires skills, it’s much easier for beginners.
In order for the finished product to be ready to smoke, it must be tight enough to pack in all the herb but also allow enough air so that you can inhale. Learning how to find this balance using rolling papers takes time and practice that can be frustrating to master.
In comparison, learning how to pack a cone is much quicker and easier to do on the go. With a cone, the basic shape is already built for you - so all you need to do is sprinkle the herb on top.
Packing a cone often results in a much more even burn because you won’t have any air pockets or bubbles that may cause the paper to canoe. That can often result in you wasting bud or having to burn the paper from the opposite side to get it back on course.
Plus, if you’re on the go and don’t have the proper set up to roll, learning how to pack cones can be a lifesaver. With rolling papers, you often need a level surface where you can focus and get the proper motion so the bud doesn’t fall out and end up lost.
With a cone you can be a bit more flexible because you can hold it upright, preventing the herb from getting lost or squandered. That’s why learning how to pack a cone is preferred by beginners and those who want more flexibility when rolling up.
Rolling Joints vs. Blunts
You may be curious about the differences between rolling a joint or rolling a blunt. Both will accomplish the same job, whether you’re learning how to pack a blunt cone or rolling it from scratch. But they each offer a unique experience that is preferred by different consumers.
The main difference between a joint and a blunt is the type of paper they’re rolled with. A joint is rolled using a thin paper - often referred to as a rolling paper - that is similar to what you may expect from a cigarette (minus the tobacco and harmful additives). In comparison, a blunt is rolled with a tobacco leaf paper, similar to a cigar or cigarillo.
Joints tend to be thinner and require less herb, whereas blunts tend to be fatter and take longer to smoke. However, it’s up to you how large you want to roll, and both can be large or small.
Due to the tobacco leaf, blunts tend to have a smokier flavor that many enjoy. Plus they add a bit of nicotine to the herb that offers an additional buzz. You can always choose to add loose tobacco to your joint - which is often known as a spliff. But spliffs typically feature more tobacco than blunts - which not everyone likes.
The process for rolling a joint vs. rolling a blunt are also different. Blunt papers are thicker, which can make them tougher to roll. But because rolling papers are thinner, it means they tear more easily, which also presents challenges.
The simplest solution is to simply learn how to pack a cone. Whether you want to learn how to pack a blunt or a joint, a cone makes the process much simpler, so you avoid wasting any herb during the learning process. Trust the Cones Factory to make this process so much simpler.
Learn How to Pack a Perfect Cone with the Cones Factory
At the Cones Factory, we supply all the tools you need to take your cannabis business to the next level. The industry is exploding and customers everywhere are looking for a simpler, more streamlined experience.
Modern smokers are looking for a fast and convenient experience, and we can help you be the company they can trust to deliver. Help your customers learn how to pack cones with quality branded products that will keep you on their minds while they are enjoying their favorite strain.
Order in bulk and stay fully stocked so you never run out of product. Reach out today if you have any questions or need recommendations.